Asia Pacific

America

Europe

Middle East

PACKAGE CONTENTS PRODUCT OVERVIEW INSTALLATION LED INDICATOR INSTRUCTION INSTALL DDPAI APP APP INSTRUCTION UPGRADE APP AND FIRMWARE SPECIFICATIONS FCC STATEMENT CAUTION CUSTOMER SUPPORT

INSTALLATION

1.Clean an area on the windshield where you wish the Dash Cam to be installed, this assists in adhesion.
2.Align the mounting bracket with the mounting Port of the dash cam, and slide it forward until it clicks into place.
3.Remove the protective film from the back of the bracket, attach the adhesive side of the bracket on the windshield where it has an unobstructed view of the road but does not interfere with the driver’s view. As shown below.

 

 

4.Use the installation tool to lift the edges of the windshield/molding and tuck in the power cable. Connect the power cable to the fuse box.

 

 

EN EN
Ideal mounting area Ideal mounting area
Fuse Box Fuse Box
Note: Most vehicles have a fuse box underneath the dashboard on the driver's or passenger's side. Note: Most vehicles have a fuse box underneath the dashboard on the driver's or passenger's side.

 

 

5.Turn on the Dash Cam after installation, you will hear "Hello, ding ding pai", the Dash Cam is powering up and will start recording, meanwhile. LED indicator blinks slowly in normal mode.
6.Loosen the studs on the bracket and adjust the camera angle. We recommend pointing the lens slightly downwards (≈10° below horizontal), to ensure that the camera view is parallel to the ground. Recommendation: The ground/sky ratio is approximately 6:4. It is recommended to adjust the Dash Cam position while looking at the screen to select the best viewing angle. After adjustment, tighten the studs on the bracket.

 

Is helpful?