▶ Type-C Charging
Open the charging cover on the back of the device and use the included power cable to connect to the Type-C interface for charging.
▶ ACC Charging Base (Optional)
Charging Accessories Overview
① Charging Base
② USB Power Cable
(Note: Please ensure that the input value of the USB port can reach at least 5V⎓2A)
③ Three-end Wire
④ Red Wire (ACC Signal Line)
⑤ Yellow Wire (VCC Power Line/Positive Pole)
⑥ Black Wire (GND Ground Wire/Negative Pole or Ground)
⑦ Fuse Box
Installation Guide
1. Choose the installation method suitable for your motorcycle:
Connect three-end wire ③ or USB power cable ② to the charging base ①.
1) Three-end wire ③ installation:
a. Connect ACC signal wire ④ to the motorcycle ACC power supply, connect VCC power wire ⑤ to VCC power supply of the motorcycle, connect GND ground wire ⑥ to the motorcycle ground wire. In this way, the camera can be turned on and off automatically with the motorcycle key.
b. If there is no motorcycle ACC, you can connect the ACC signal line ④ to the motorcycle ignition interface, such as headlights, etc.
c. If there is no motorcycle ACC, you can connect the ACC signal wire ④ and the VCC power wire ⑤ together and connect them both to the positive pole of the motorcycle power supply. The GND ground wire ⑥ is connected to the motorcycle's ground wire. After completing the wiring, the camera will automatically turn on/off. After the motorcycle is turned off, please remember to take the camera away to avoid consuming the motorcycle battery and cover the power base with a waterproof and dustproof cover.
It is recommended to connect the camera to the motorcycle ACC power supply.
2）USB power cable ② installation:
Plug the USB connector of the USB power cable into the USB port of the motorcycle.
2. Use cable ties to secure and store excess wire length. When fixing and removing wires, please keep them away from anklets/movable mechanisms/high-temperature devices, etc.
Before installing the camera, if there is water or dirt on the ACC charging base, please wipe it dry before installing the device. When not in use, please cover it tightly with a waterproof and dustproof cover to prevent foreign matter from remaining.
